Use duster and or vacuum gently with appropriate fitting.
How Your Personalised Table Lamps Work
The great news is that your unique, handmade lamp arrives pre-assembled. This makes set-up nice and simple.
Step 1: Open
It's arrived. Your lamp has been lovingly handmade. The fire rated inner lining has been carefully stitched in and it's been delivered to you. Time to open it up and marvel at its splendour.
Step 2: Insert bulb
Bulbs not included. For this you need a standard bayonet cap B22 bulb (E27 if you opted for the EU version) that is no higher than 40w for the small lamp, or 60w for the large. Bayonet cap bulbs operate using a simple push and twist mechanism. There are two small pins on either side of the cap, line these up with the fitting (you can usually tell by touch, and won't need to try and get your head and hands in the lamp at the same time) then put a little pressure on it and twist it round until it wont go any further. Ta-da, your bulb is installed. (For E27 bulbs there is a standard thread, all you need to do is screw it in)
Step 3: Plug in your lamp
Find a suitable plug socket, and plug your lamp into your mains supply. If you are using an extension, as always, be careful not to overload it. The cable for your custom table lamp is 1.8 metres long so you will have plenty of options for where to place it.
Step 4: Switch on
That's it, you're done. As simple as that. Switch your bespoke desk lamp on using the inline switch and you're good to go.